Measurements of surface contamination of spray equipment with pesticides after various methods of application

Abstract

A traditional method to determine operator dermal exposure is to quantify the amount of pesticide coming into contact with specific body regions and then to integrate the deposition density values with the total body surface. It is known that extremely high deposition values may occur in the hand region; however, the source of contamination is generally assumed to be direct splash or contact with the pesticide container. One of the parameters affecting operator/pilot exposure could be the transfer of pesticide residue, particularly in the case of pesticides with a longer half‐life, from contaminated surfaces of spray equipment by direct contact over extended periods. If the rate of skin absorption of pesticide is readily known, the expected values of daily dose for an operator or pilot may significantly rise due to the extended contact period. This study produced field data on the surface contamination of spray equipment used for ground and aerial applications. If field data on precise work practice (time‐motion) observations are incorporated, it may be possible to estimate the potential exposure of operator/pilot due to hand contact with contaminated surfaces.     

CuO-CeO2/AC吸附燃煤烟气中元素汞的实验研究

通过活性炭负载CuO和CeO2来制备吸附剂,采用固定床吸附方式,在不同反应条件下对吸附剂的吸附性能进行测试,筛选出去除效率最好的吸附剂,并通过BET和XRD对吸附剂的理化性质进行分析。结果表明,CuO和CeO2的加入大大改变了原活性炭的比表面积和孔结构,改善了活性炭的吸附性能。CuO-CeO2/AC中CuO和CeO2质量比不同,对汞的去除效率也不同,在1∶2时去除效率最好;CuO-CeO2/AC中所负载的CuO和CeO的总量为5%时,能大大促进汞的吸附效率,增长有效吸附时间;CuO-CeO2/AC对汞的吸附性能随反应温度的增加呈先增加后减小的趋势,在80℃时达到最大值。     

抗铬菌株的筛选鉴定及其生物学特性和吸附特性

利用微生物分离纯化技术,在培养基中加入不同浓度的Cr3+、Cr6+,经过长时间驯化,从污染土壤中筛选出2株对Cr具有较高抗性的菌株(A和B),对其进行了形态、生理生化特性及分子生物学鉴定,并研究了其最佳生长条件及对Cr3+的生物吸附规律。结果表明,菌株A和B分别为蜡状芽孢杆菌(Bacillus cereus)和米根霉菌(Rhizopus oryzae)。菌株A和B的最适生长pH值均为7,最适生长温度均为30℃,最佳装液量为80~100 mL(250 mL摇瓶)。在培养时间一定时,随着Cr3+浓度的增加,菌株对Cr3+的吸附率减少,而生物吸附量则逐渐增大;在Cr3+浓度一定时,随着培养时间的延长,菌体对Cr3+的吸附率呈现出先增加后减少的趋势,这与生物吸附量的变化趋势基本一致。在Cr3+浓度为100 mg/L时,菌株A和B对Cr3+的吸附率达到最大,分别为51.47%和46.36%。     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.     

改性沸石分离富集-火焰原子吸收光谱法测定长江水中镉

采用改性沸石分离富集-火焰原子吸收光谱法测定长江水中微量镉,优化了富集和洗脱条件,讨论了干扰离子的影响。方法在0μg~4.00μg范围内线性良好,检出限为0.214μg/L,长江水平行测定的RSD为1.8%,加标回收率为99.0%~104%。     

Use of co-combustion bottom ash to design an acoustic absorbing material for highway noise barriers

The present study aims to determine and evaluate the applicability of a new product consisting of coal bottom ash mixed with Portland cement in the application of highway noise barriers. In order to effectively recycle the bottom ash, the influence of the grain particle size of bottom ash, the thickness of the panel and the combination of different layers with various particle sizes have been studied, as well as some environmental properties including leachability (EN-12457-4, NEN-7345) and radioactivity tests. Based on the obtained results, the acoustic properties of the final composite material were similar or even better than those found in porous concrete used for the same application. According to this study, the material produced presented no environmental risk.     

原子吸收石墨炉技术测定水中痕量阴离子洗涤剂

本文研究了用乙二胺铜(Ⅱ)—氯仿作为络合—萃取体系,石墨炉原子吸收技术间接测定水中痕量阴离子洗涤剂的一种方法。其检出限为2.0ug/1,加标回收率为89.6%～104.5%。具有选择性好、灵敏度高、快速简便等特点。同时还研究了水样的酸度和共存离子对测定的影响。对于用原子吸收进行有机分析具有一定的实际意义。     

剥壳机系统噪声控制技术

剥壳机生产系统将胡豆打碎和去壳时发出严重的扰民噪声,对产生噪声的设备和管道采用隔声和吸声控制措施。结果表明,效果十分明显,达到了国家环境噪声排放标准。     

AAS与ICP－AES间接测定天然水中硫酸盐

本文以与过量形成ＢａＳＯ＿４沉淀反应为基础，较详细地讨论了反应条件、从而拟定了用ＡＡＳ和ＩＣＰ－ＡＥＳ间接测定天然水中的方法、确定了方法的精密度，ＡＡＳ法的ＲＳＤ％为１．５，ＩＣＰ－ＡＥＳ法为３．２．两种方法对比分析的结果接近，误差为１．０％（相对）。用于天然水中的测定，获得满意的结果。     

Effects of Starch Moisture on Properties of Wheat Starch/Poly(Lactic Acid) Blend Containing Methylenediphenyl Diisocyanate

Methylenediphenyl diisocyanate was found to improve the interfacial interaction between poly(lactic acid)(PLA) and granular starch. The objective of this research was to study the effect of starch moisture content on the interfacial interaction of an equal-weight blend of wheat starch and PLA containing 0.5% methylenediphenyl diisocyanate by weight. Starch moisture (10% to 20%) had a negative effect on the interfacial binding between starch and PLA. The tensile strength and elongation of the blend both decreased as starch moisture content increased. At 20% moisture level, the starch granules embedded in the PLA matrix were observed to be swollen, resulting in poor strength properties and high water absorption by the blend.